Show Posts
1
General / Clipping info is contradictory in analysis table vs spectrum analysis
« on: March 31, 2017, 01:42:34 »
Clipping info is contradictory in analysis table vs spectrum analysis:
The table shows massive clipping 10000 to 900000. But if I right click on one of these tracks, and do "spectrum analysis" the graphs shows no clipping. The graph shows minus (-) 20dB or lower for everything.
Clipping is when the input is over 0 dB so it is clipped to 0 dB (where 0 dB is the maximum possible signal). So if there is actually clipping, it should show on the red portion of the graph being near 0 dB.
I listen to these and I can not tell if there is clipping, so maybe there is none. Maybe the table clipping is wrong.
The table shows massive clipping 10000 to 900000. But if I right click on one of these tracks, and do "spectrum analysis" the graphs shows no clipping. The graph shows minus (-) 20dB or lower for everything.
Clipping is when the input is over 0 dB so it is clipped to 0 dB (where 0 dB is the maximum possible signal). So if there is actually clipping, it should show on the red portion of the graph being near 0 dB.
I listen to these and I can not tell if there is clipping, so maybe there is none. Maybe the table clipping is wrong.